Ning He

Nanjing, 211816, China

Last Updated: 09/26/2026

Save publications for later

Sign Up

Not sure about your diagnosis?

Check Your Symptoms

Found 12 publications

Coaxial spinning of Ti3C2TX MXene fibers with spontaneous radial densification achieves simultaneous improvements in both mechanical strength and charge storage ability.

Coaxial spinning of Ti3C2TX MXene fibers with spontaneous radial densification achieves simultaneous improvements in both mechanical strength and charge storage ability.

Journal: Nanoscale

Published: February 05, 2026

Numerical and Experimental Investigation on a "Tai Chi"-Shaped Planar Passive Micromixer.

Numerical and Experimental Investigation on a "Tai Chi"-Shaped Planar Passive Micromixer.

Journal: Micromachines

Published: May 31, 2023

Effect of Tool Coatings on Machining Properties of Compacted Graphite Iron.

Effect of Tool Coatings on Machining Properties of Compacted Graphite Iron.

Journal: Micromachines

Published: August 29, 2022

Experimental Research on Deep-And-Narrow Micromilled Grooves Using a Self-Fabricated PCD Micro-Cutter.

Experimental Research on Deep-And-Narrow Micromilled Grooves Using a Self-Fabricated PCD Micro-Cutter.

Journal: Micromachines

Published: September 04, 2021

Estimation of Machining Sustainability Using Fuzzy Rule-Based System.

Estimation of Machining Sustainability Using Fuzzy Rule-Based System.

Journal: Materials (Basel, Switzerland)

Published: July 30, 2021

Experimental Study on Fabrication of CVD Diamond Micro Milling Tool by Picosecond Pulsed Laser.

Experimental Study on Fabrication of CVD Diamond Micro Milling Tool by Picosecond Pulsed Laser.

Journal: Micromachines

Published: June 30, 2021

On Coolant Flow Rate-Cutting Speed Trade-Off for Sustainability in Cryogenic Milling of Ti-6Al-4V.

On Coolant Flow Rate-Cutting Speed Trade-Off for Sustainability in Cryogenic Milling of Ti-6Al-4V.

Journal: Materials (Basel, Switzerland)

Published: April 30, 2021

Between-the-Holes Cryogenic Cooling of the Tool in Hole-Making of Ti-6Al-4V and CFRP.

Between-the-Holes Cryogenic Cooling of the Tool in Hole-Making of Ti-6Al-4V and CFRP.

Journal: Materials (Basel, Switzerland)

Published: January 04, 2021

Experimental Investigation on Direct Micro Milling of Cemented Carbide.

Experimental Investigation on Direct Micro Milling of Cemented Carbide.

Journal: Micromachines

Published: January 14, 2019

Research on High Performance Milling of Engineering Ceramics from the Perspective of Cutting Variables Setting.

Research on High Performance Milling of Engineering Ceramics from the Perspective of Cutting Variables Setting.

Journal: Materials (Basel, Switzerland)

Published: November 10, 2018

Multi-Objective Optimization for Grinding of AISI D2 Steel with Al₂O₃ Wheel under MQL.

Multi-Objective Optimization for Grinding of AISI D2 Steel with Al₂O₃ Wheel under MQL.

Journal: Materials (Basel, Switzerland)

Published: October 26, 2018

Research on the Relationship between Cutting Force and Machined Surface Quality in Micro Ball End-Milling of Potassium Dihydrogen Phosphate Crystal.

Research on the Relationship between Cutting Force and Machined Surface Quality in Micro Ball End-Milling of Potassium Dihydrogen Phosphate Crystal.

Journal: Micromachines

Published: October 07, 2018

Showing 1-12 of 12

Last Updated: 09/26/2026