Thomas G. Schratzenstaller
Regensburg, BY 93053, Germany
Last Updated: 09/26/2026
Save publications for later
Sign Up
Not sure about your diagnosis?
Check Your Symptoms
Found 14 publications
Physiological limits of syringe pressure during mechanical fat processing using a 10-mL syringe.
Journal: Plastic and reconstructive surgery
Published: June 15, 2026
Quantification of Cannula Influence on Negative Pressure in Syringe-Assisted Liposuction.
Journal: Plastic and reconstructive surgery
Published: September 24, 2025
Hemocompatibility and cytotoxicity evaluation of additively manufactured and surface-treated 316 L stainless steel aortic stents using laser powder bed fusion (L-PBF).
Journal: Journal of materials science. Materials in medicine
Published: August 21, 2025
A re-usable 3D-printed training model for the endodontic management of dental trauma in immature teeth.
Journal: International endodontic journal
Published: January 31, 2025
Surface Treatment of Additively Manufactured Polyetheretherketone (PEEK) by Centrifugal Disc Finishing Process: Identification of the Key Parameters.
Journal: Polymers
Published: July 24, 2024
The Effects of Shear Force-Based Processing of Lipoaspirates on White Adipose Tissue and the Differentiation Potential of Adipose Derived Stem Cells.
Journal: Cells
Published: July 25, 2022
Introduction of a New ex vivo Porcine Coronary Artery Model: Evaluation of the Direct Vascular Injury after Stent Implantation with and without Dogbone Effect.
Journal: European surgical research. Europaische chirurgische Forschung. Recherches chirurgicales europeennes
Published: February 21, 2022
Results of WICOVIR Gargle Pool PCR Testing in German Schools Based on the First 100,000 Tests.
Journal: Frontiers in pediatrics
Published: June 07, 2021
Shear Force Processing of Lipoaspirates for Stem Cell Enrichment Does Not Affect Secretome of Human Cells Detected by Mass Spectrometry In Vitro.
Journal: Plastic and reconstructive surgery
Published: November 25, 2020
Computational analysis of the effects of geometric irregularities and post-processing steps on the mechanical behavior of additively manufactured 316L stainless steel stents.
Journal: PloS one
Published: September 21, 2020
Last Updated: 09/26/2026